I’ve been experimenting with using a PIC to control long chains of 7-segment LED displays, and to find an approach that I can use to replace the obsolete TIL311 displays. To that end, I’ve created a tech article that describes a simple way to do this. My prototype was 24 digits long; long enough for most applications I think, but could be extended. It’s all done with a PIC18F25K22 running from its own internal oscillator, accepts data from a serial device at 9600 baud, and supports 0 to 9, and A to F value display. The code is written in AMICUS18 BASIC which is free so you can change the software to suit your own application. All the fully documented source code is supplied as well as a schematic of the circuit.
The picure above shows 24 digits (6 x 4 digit modules). The display modules each contain a 4 x 7 segment Common Cathode display, a DIL resisor pack on the modules right-hand side, and there are 4 n-channel SMT MOSFETS underneath.
The advantage of using modules on breadboards is the vast amount of time, and wire that's saved. You can throw a quick circuit together in no-time if you already have the modules pre-built. It also saves a lot of breadboard space.
The picure above shows 24 digits (6 x 4 digit modules). The display modules each contain a 4 x 7 segment Common Cathode display, a DIL resisor pack on the modules right-hand side, and there are 4 n-channel SMT MOSFETS underneath.
The advantage of using modules on breadboards is the vast amount of time, and wire that's saved. You can throw a quick circuit together in no-time if you already have the modules pre-built. It also saves a lot of breadboard space.
RSS Feed
